When it comes to sliding doors, there are so many choices available that sometimes it's hard to find what you are looking for. There are brands, finishes, sizes, and budgets as well. From these factors, you have different types of designs and styles of sliders that make choosing one particular type of door an overwhelming task. To help you understand the process of installing a sliding door, we've broken down the job into easy steps.
Installing a Sliding door system is a good alternative if you’re working with a small bedroom, bathroom, or kitchen as it gives you more space.
A sliding door is a great addition to any home or apartment. It gives you extra storage space and occupies less space than regular doors. Installing a sliding door is not a big deal but requires careful attention to detail.
A door can be the main part of a home. It’s the first thing that people see when they enter a house and the last thing one sees before leaving. That is why everything should be perfect about this particular element of the interior design, especially its installation and maintenance. A stainless steel sliding door is great for many different homes and has a lot of advantages. Installation is precise, durable, and has a low cost.
Installing a sliding door to your patio or home can help you get a lot of natural sunlight, save energy and breathable fresh air.
How to Install a Sliding Door
Step 1: Remove the Old Door
The first step is removing the old door. This can be tricky if the door has been painted multiple times. Start by taking off all of the moldings around the frame with a utility knife or a pry bar. Then, remove the exterior trim on the outside of the door with a screwdriver or drill. If you run into problems prying off the molding or trimming, heat it up with a hairdryer or heat gun to soften any paint that may be holding it in place. After you remove all of the trimming and molding, knock out any nails left in the frame with a hammer and clean out the dust from drilling and sawing.
Step 2: Measure
Start by measuring the width and height of the opening for your new sliding door. Purchase a door that is slightly smaller than the width and height of your opening. The reason for this is that you will have to fill in the gaps around your sliding door with trim.
Step 3: Cut
Next, use a reciprocating saw or jigsaw to cut through any trim around the doorway opening that may be blocking the hole for your new sliding door. You will want to measure three times before cutting once! Also, make sure you remove any nails or screws before you start cutting. Make sure that your cuts are clean and even so that you can reinstall the trim when you are finished installing the sliding door.
Step 4: Pick Out the Sliding Door
The first step to installing a sliding door is to pick out a Pocket sliding doors that fits your home. There are many different styles and sizes of these doors, so make sure you pick one that fits within your budget as well as looks attractive with your home's decor.
Step 5: Installing the bottom track
The next step is to install the bottom track. Start by attaching it to the floor with screws. Then, position it over your cut-out opening and use a screw gun to attach it from above as well. Check your work and then install the other side of the track, making sure that the two are properly aligned.
Also Read : 6 Common Problems Caused by Poor Window Installation
Comments
Post a Comment